homepage › Forums › BridgePoint/xtUML Usage and Training › Sequence Capture View
- This topic has 3 replies, 2 voices, and was last updated 4 years, 5 months ago by
cort.
-
AuthorPosts
-
August 5, 2016 at 7:53 pm #5628
Dennis Tubbs
ParticipantHow does the sequence capture view work in BridgePoint? Is there some documentation somewhere?
Thanks,
DennisAugust 5, 2016 at 8:19 pm #5629cort
KeymasterHi Dennis,
This feature was never made an official part of the tool. It was delivered but disabled by default. It did not get very much use, so it was discontinued when special-purpose packages were deprecated.
If it is important, the source could be found.
Or, you could run the old version of the tool (probably 3.2 or 3.3).
CortAugust 5, 2016 at 8:19 pm #5630cort
KeymasterHi Dennis,
This feature was never made an official part of the tool. It was delivered but disabled by default. It did not get very much use, so it was discontinued when special-purpose packages were deprecated.
If it is important, the source could be found.
Or, you could run the old version of the tool (probably 3.2 or 3.3).
CortAugust 5, 2016 at 8:20 pm #5631cort
KeymasterHi Dennis,
This feature was never made an official part of the tool. It was delivered but disabled by default. It did not get very much use, so it was discontinued when special-purpose packages were deprecated.
If it is important, the source could be found.
Or, you could run the old version of the tool (probably 3.2 or 3.3).
Cort -
AuthorPosts
- You must be logged in to reply to this topic.